[an error occurred while processing this directive]
|
Не утишительный результат
avreal/WIN32 - AVR controllers LPT programmer by Redchuk Alexandr
v1.25rev4 (Mar 24 2006 08:54:51) http://www.ln.com.ua/~real/avreal
bug-reports, suggestions and so on mail to avreal@real.kiev.ua
Command:
-p1 -as +mega16 -o0,8 -w -f_low=e1,_high=99 -%
% Fuse byte added: _LOW=E1
% Fuse byte added: _HIGH=99
% LPT base port 0x378
% assume that LPT data writes not faster then 1uS
% Atmel adapter for STK*00 found
% STK mode
% osc = 0kHz -> XTAL will be generated
% with SCK low 16 periods, high 16 periods
% Reset
% PgmOn reply 0x00AC5300
% Synchronised after 1 try
% GetID reply 0x00300000
% GetID reply 0x00300001
% GetID reply 0x00300002
% Read ID: 0x000102
Device connected, but not recognised, ID: 0x000102 (looks as protected)
% ReadLock command 0x58000000
% ReadLock reply 0x00580000
Chip locked - reading and programming disabled
% ReadOsccal command 0x38000000
% ReadOsccal reply 0x00380000
% ReadOsccal command 0x38000100
% ReadOsccal reply 0x00380001
% ReadOsccal command 0x38000200
% ReadOsccal reply 0x00380002
% ReadOsccal command 0x38000300
% ReadOsccal reply 0x00380003
Can't continue
Reset pin released
Adapter disabled
неутишительный результат..
Кстати ключ -wv это видать ошибка, на него выругалось
ставил -w и -v пробовал тоже