Сами подумайте, какой смысл указывать с кратностью 2мА, чтобы потом округлять до 100мА? Вы наверное вот в этом абзаце запутались?
Отправлено
rezident 16 марта 2008 г. 00:43
В ответ на: Питание USB - блок 2mA или 100mA? отправлено
microprogs 16 марта 2008 г. 00:05
7.2.1 Classes of Devices The power source and sink requirements of different device classes can be simplified with the introduction of the concept of a unit load. A unit load is defined to be 100 mA. The number of unit loads a device can draw is an absolute maximum, not an average over time. A device may be either low-power at one unit load or highpower, consuming up to five unit loads. All devices default to low-power. The transition to high-power is under software control. It is the responsibility of software to ensure adequate power is available before allowing devices to consume high-power.