[an error occurred while processing this directive]
[an error occurred while processing this directive]
|
Fuse для MSP430F я сам не прожигал. Из известных средств программирования это умеет делать только программатор PRGS430.
В последнем даташите (slas272c.pdf) приведены параметры прожигания:
(page 53)
Fuse-blow voltage, F versions (see Note 54)(VCC=2.2V/3V) 6.0-7.0 V
Supply current on TDI with fuse blown 100 mA
Time to blow the fuse 1 ms
Note 54. The supply voltage to blow the fuse is applied to the TDI pin.
E-mail: info@telesys.ru