|
Вот выдержка из апликухи на применяемый модуль. Вопрос вот в чем:
Почему PCICLK должен иметь задержку именно 1150пс? Вроде как эта трасса должна быть длиннее самой длинной в шине или я не прав?
The PCICLK signal that comes from the X-board™ module
is timed for an external trace delay of 1150ps from the
X-board™ output pin to the PCI device’s clock pin.
(including from and to zero delay buffers)
The trace length from the X-board™ clock pin to a PCI
device on the baseboard should be about 7.7inch (if a
typical figure for baseboard PCB propagation delay of
150pS per inch is used). If a more accurate value is
available for PCB propagation delay, it should be used in
place of the 150pS/inch rule-of-thumb to calculate the
clock trace lengths.