Я считаю, что тебе следует обащаться ко мне на Вы. Так же как и я к тебе. Не вижу повода для перехода с твоей стороны на "ты" это во первых. А во вторых- читай внимательно ДШ если уж что-то берешься советовать. Повторяю выдержку из ДШ ниже.
(«Телесистемы»: Конференция «Микроконтроллеры и их применение»)

миниатюрный аудио-видеорекордер mAVR

Отправлено UraGun 24 мая 2006 г. 12:00
В ответ на: Превышение паспортных значений и есть та махровая радиолюбительщина, на которую тебе все указывали при обсуждении твоей продукции. Делаешь туфту сам - дело твое, но незачем советовать это другим отправлено =AVR= 24 мая 2006 г. 11:55

Although each I/O port can sink more than the test conditions (20mA at Vcc = 5V, 10mA at Vcc = 3V) under steady state
conditions (non-transient), the following must be observed:
PDIP Package:
1] The sum of all IOL, for all ports, should not exceed 400 mA.
2] The sum of all IOL, for ports C0 - C5 should not exceed 200 mA.
3] The sum of all IOL, for ports B0 - B7, C6, D0 - D7 and XTAL2, should not exceed 100 mA.
TQFP and MLF Package:
1] The sum of all IOL, for all ports, should not exceed 400 mA.
2] The sum of all IOL, for ports C0 - C5, should not exceed 200 mA.
3] The sum of all IOL, for ports C6, D0 - D4, should not exceed 300 mA.
4] The sum of all IOL, for ports B0 - B7, D5 - D7, should not exceed 300 mA.
If IOL exceeds the test condition, VOL may exceed the related specification. Pins are not guaranteed to sink current greater
than the listed test condition.

Составить ответ  |||  Конференция  |||  Архив

Ответы



Rambler's Top100 Рейтинг@Mail.ru
Перейти к списку ответов  |||  Конференция  |||  Архив  |||  Главная страница  |||  Содержание

E-mail: info@telesys.ru