Table 10–23. Document Revision History "Changed VCCIO to VCCA for MSEL pin connection in “Configuration Schemes”" да и во всех других местах (по тексту Cyclone III Device Handbook подчеркивается, что нужно MSEL и JTAG надо тянуть к VCCA а не к VCCIO! Даже такое заявление чего стоит: To avoid any problems with detecting an incorrect configuration scheme, hard-wire the MSEL pins to VCCA or GND without any pull-up or pull-down resistors. Do not drive the MSEL pins with a microprocessor or another device. (стр 10–2) VCCA - Supply (analog) voltage for PLL regulator - min=2.375 2.5 max=2.625