Отправлено Postoroniy_v 26 января 2005 г. 10:09 В ответ на: Уважаемые! Подскажите, можно ли в Qurtus указать состояние триггера в котором он будет находиться после конфигурирования, и если можно, то как? отправлено DeadMoroz 26 января 2005 г. 09:47

A logic option that allows the Compiler to push an inversion (that is, a NOT gate) back through a register and implement it on that register's data input if it is necessary to implement the design. If this option is turned on, a register may power up to an active-high state, so it may need to be explicitly cleared during initial operation of the device.

This option is ignored if it is applied to anything other than an individual register or a design entity containing registers. If it is applied to an output pin that is directly fed by a register, it is automatically transferred to that register. This option can be set in the Assignment Editor (Assignments menu) or the Analysis & Synthesis Settings page or the Fitter Settings page of the Settings dialog box (Assignments menu). This option is available for all Altera® devices supported by the Quartus® II software.