[an error occurred while processing this directive]
|
Цитата:
The nINIT_CONF pin is only available on EPC2 devices and has an internal pull up of 1 k¾ that is always active. If
nINIT_CONF is not available or not used, nCONFIG must be pulled to VCC either directly or through a 1-k¾ resistor.
Вот.. А вопрос собственно в следующем: а если nINIT_CONF is not used, то каким образом начинается конфигурация?
E-mail: info@telesys.ru