|
|
;----------------------------------------------
В начале загнал в медленный режим эмулятор:
----- Current operating mode:
XDS510 Emulation mode = JTAG
Brakes = 2 PCI clocks
LPT JTAG/Emu Mode = ByteBlaster MV
XDS510 TCK freq = 7.69 Mhz
XDS510 Link delay = Normal
XDS510 Cable TDO Ctl = Enabled
XDS510 POD TDO Ctl = Enabled
Operation completed successfully;----------------------------------------------
Затем прогнал xdsprobe с параметрами y и i:xdsprobe -y
None of the test-cases have detected errors.xdsprobe -i
The JTAG IR integrity test has succeeded.
The JTAG DR integrity test has succeeded.
;----------------------------------------------
Сконфигурировал ccBrd0.dat# config version=3.5
@ TMS320C5500_0 family=tms320c55xx
$ sepk
pod_drv=xds510.dll
pod_port=240
pod_access=direct
$ /
$ uscif
linkdly=3
$ /
# /
;----------------------------------------------
Захожу в CCS:
Error connecting to the target:
Error 0x80000240/-1156
Fatal Error during: Initialization, OCS,
Invalid data was scanned by the emulation controller.
Verify the board setup to make sure the scan chain is properly
defined.
If the setup is correct, then RESET EMULATOR. This will disconnect each
target from the emulator. The targets should then be power cycled
or hard reset followed by an emureset and reconnect to each target.Sequence ID: 0
Error Code: -1156
Error Class: 0x80000240
I/O Port = 240Board Name: C5509 XDS510 Emulator
Cpu Name: TMS320C5500_0
;----------------------------------------------
Для проверки снял питание от TARGET на PODError connecting to the target:
Error 0x80000240/-180
Fatal Error during: Initialization, OCS,
This error was generated by TI's USCIF driver.SC_ERR_CTL_NO_TRG_POWER <-180>
The controller has detected a target power loss.
The user may have failed to turn-on or connect its source.
;--------------------------------------------------------Где чего еще посотреть?
Спасибо.
|
|
E-mail: 
info@telesys.ru
