[an error occurred while processing this directive]
|
This utility has determined the operating system is WinXP.
The operating system has Service Pack 2 installed.
This utility will operate on port `0x0240'.
This utility has detected a XDS510 class controller.
The revision number of the support-logic is 2.
The revision number of the controller is 1.
The type of the controller is a TBC device (74ACT8990).
This utility will attempt to reset the controller.
The controller has been hardware reset via its support logic.
The controller has been software reset via its support logic.
The controller is configured to allow use of XL functions.
The controller is configured for normal clock operation.
The controller will use falling-edge timing on output-pins.
The controller may use rising-edge timing on input-pins.
The scan-path link-delay will be set to a length of 4 bits.
The support logic has not detected any previous power-loss.
The scan-path will be reset by toggling the JTAG TRST signal.
This utility has successfully reset the controller.
C:\Program Files\Far>
1Help 2UserMn 3View 4Edit 5Copy 6RenMov 7MkFold 8Delete 9ConfMn 10Quit
E-mail: info@telesys.ru