|
|
READY I
"Data ready. READY indicates that an external device is prepared for a bus transaction to be completed. If the
device is not ready (READY is low), the processor waits one cycle and checks READY again. Note that the
processor performs ready detection if at least two software wait states are programmed. The READY signal is
not sampled until the completion of the software wait states."
MSC O/Z
"Microstate complete. MSC indicates completion of all software wait states. When two or more software wait
states are enabled, the MSC pin goes active at the beginning of the first software wait state and goes inactive
high at the beginning of the last software wait state. If connected to the READY input, MSC forces one external
wait state after the last internal wait state is completed."
Не ясна функция этих двух ножен. Вроде как вместе могут выполнять какую-то функцию. А какую? Где эта функция может быть применена на практике?
E-mail: 
info@telesys.ru
